A tv wall mount is an excellent way to hang your TV, making it easier to watch and allowing you to save space in a room. The best part is, almost any new TV can be mounted on the wall, as long as it has mounting holes that meet the Video Electronics Standards Association (VESA) interface standard. You can also use a wall mount for an older TV that you don’t want to keep on a stand, but which doesn’t have the mounting holes necessary for installing a new television.
While it may seem daunting at first, mounting a TV is actually fairly simple and can be done in just a few hours. The main things you need to do are locate a place on your wall to install the mount and make sure it’s at or close to eye level for everyone in your household. Once the location is settled, you should carefully mark the wall with light pencil marks where the pilot holes are to be drilled. A good drill or screwdriver with a masonry bit should then be used to drill these holes, which will eventually hold your mounting screws and plate in place. It’s important to take your time doing this step, as if the marks are not precise enough the mounting plate could be damaged or loosen up over time.
Once the holes are drilled, it’s time to attach the wall bracket and plate to your TV. Most tv mount kits will contain all the screws needed for completing this task, though you may need to visit your local hardware store or a home improvement center to pick up some additional screw sizes if the ones provided are not suitable for your specific model. This is because the size of studs in a wall can vary considerably. For example, most studs are spaced 16 inches apart in modern homes, but custom-built or historic buildings that don’t follow standardized construction practices might have them spaced closer together, or even farther apart.
Finally, you should use the included cable management channels to route any power or HDMI cables through the wall mount. This will help prevent them from becoming tangled or damaged as you move the TV around, or plug in different playback devices. You should also be careful not to over-tighten the screws, as this can damage the chassis of the TV or strip the screw heads, making it more difficult to mount (or later unmount) the television.
After the TV and the plate are attached to the wall, it’s a good idea to test your set up by sitting in front of it and making sure it is at the right height for comfortable viewing. You can also adjust the angle of the TV to ensure it is perfectly centered on the wall, which is especially important in rooms with a lot of seating options. At this point, you should be ready to enjoy your new TV!